Processing characteristics of titanium

In addition to pure titanium, nearly 30 types of titanium alloys have been produced in the world. The most widely used titanium alloys are Ti-6Al-4V, Ti-5Al-2.5Sn, and so on. The industrial method for the production of titanium metal is the Kraul method, and the product is a titanium sponge. The traditional process of making titanium is to melt and cast sponge titanium into ingots, and then process them into titanium. According to this, the main steps of the technological process from mining to making titanium are:

Titanium Ore->Mining->Ore Dressing->Too Concentrated Ore->Enrichment->Titanium-rich Material->Chlorination->Crude TiCl4->Refined->Pure TiCl4->Magnesium Reduction->Sponge Titanium->Melt Casting-> Titanium Ingot -> Processing -> Titanium Material or Titanium Parts In the above steps, if the rutile is obtained by mining, it does not need to be enriched and can be directly chlorinated to obtain crude TiCI4. In addition, the casting operation should be a metallurgical process, but sometimes it is also classified as a processing process.

The processing in the above process refers to plastic processing and casting. Plastic processing methods include forging, extrusion, rolling, stretching and so on. It can process titanium ingots into various sizes of cakes, rings, plates (titanium plates), pipes, bars, profiles and other products, and can also be cast into various shapes of parts and components.

The plastic processing of titanium and titanium alloys has the characteristics of large deformation resistance; normal temperature plasticity difference, high yield limit and strength limit ratio, large rebound, sensitivity to notches, easy to bond with the mold during deformation, and easy to absorb harmful gases when heated, etc. Plastic processing is more difficult than steel and copper.

Therefore, the processing technology of titanium and Titanium Alloy Rectangular Tube must consider these characteristics.

Titanium adopts plastic processing, the size of adding soil is not limited, and it can be mass-produced, but the yield rate is low, and a large amount of scraps and residues are generated during the processing.

Aiming at the above shortcomings of titanium plastic processing, powder metallurgy technology has been developed in recent years. The powder metallurgy process of titanium is the same as ordinary powder metallurgy, except that the sintering must be carried out under a vacuum. It is suitable for the production of large-volume, small-sized parts, and is especially suitable for the production of complex parts. This method requires almost no processing and has a high yield rate. It can not only make full use of titanium waste as raw materials, but also reduce production costs, but it cannot produce large-size grade 5 titanium round rod parts. The powder metallurgy process of titanium is: titanium powder (or titanium alloy powder) -> sieving -> mixing -> press forming -> sintering -> auxiliary processing -> titanium products.